GE Monogram Ventilation Hood ZVC48LSS User Manual

ZVC48LSS

GE Monogram^®48" Custom Hood Insert

Custom Insert Liner

Dimensions and Specifications (in inches)

Outside Dimensions

The custom canopy must be sized to ﬁt the insert sleeve.

Construct the canopy with an opening that is:

38-3/4"W x 13-3/16"D

The opening must be constructed of 3/4" thick material to

allow the sleeve locking clips to engage.

The Insert Sleeve

The Supplied Liner

A stainless steel liner is shipped with each hood insert. This

non-combustible liner protects the underside of the canopy.

Custom Liner

If you are not using the supplied liner, you may construct a

custom non-combustible liner. Use the supplied liner as a

template. The opening must be 38-3/4"W x 13-3/16"D.

3/4" thick material must surround the opening to allow the

sleeve locking clips to engage. The insert sleeve inside the

cabinet should be positioned 1/2" from the rear wall so that

the center of the 8" duct is 5-1/2" from the rear wall.

Remote Location for the Control

The control may be removed from the hood and installed

into a wall or countertop. A 30-ft length of wire is supplied to

accommodate most installations. A blanking plate covers the

opening when the controls are removed. The overall size of

the control is 4-1/4" wide and 2-1/4" deep.

3-11/16"

1-11/16"

For answers to your Monogram,^®GE Profile^™or

GE^®appliance questions, visit our website at

ge.com or call GE Answer Center^®service,

800.626.2000.

We recommend that the cutout in granite or other hard

surfaces be made before the countertop is installed.

Specification Created 10/06

130670